W-DN 2 ceiling nail
Ceiling nail W-DN 2
ANC-(W-DN 2)-(A2K)-5-6X40
Register now and access more than 150,000 products
- For efficient push-through installation
- Low drilling effort due to small drill hole depth and small drill hole diameter
- No additional drill hole cleaning necessary - three-factor ventilation of the drill bit is sufficient
- No additional drill hole cleaning is necessary when using the Würth dust extraction drill bit
- Easy insertion: Knock in the protruding pin with a hammer until flush
- Can be loaded immediately - no need to wait
- No special drilling or setting tools required
- Reliable and proven anchorage via friction locking - displacement-controlled expansion anchors
Datasheets(X)
Anchors in a redundant non-structural system with approval/assessment in accordance with EN 1992-4:2018 in concrete
- In normal weight concrete C20/25 to C50/60 (cracked and uncracked concrete)
- Fastenings subject to exposure to fire
For fastening lightweight fixtures
- Lightweight ceiling cladding and suspended ceilings, metal profiles, punched strips, wire hangers, vernier hangers, wooden battens, wooden slats, squared timbers etc.
W-DN 2 (zinc-plated steel) may only be used in dry indoor conditions.
Easy installation: Insert, knock it in flush, and done!
 | |
Type description | W-DN |
Material | Steel |
Surface | Zinc plated |
Anchor diameter | 6 mm |
Length | 40 mm |
Max. attachment height (t fix) | 5 mm |
Effective anchoring depth (h ef) | 32 mm |
Nominal drill-bit diameter (d 0) | 6 mm |
Drill hole depth (h 0) | 40 mm |
Through-hole in the component to be connected (d f) | 7 mm |
| All load directions Admissible load at every angle Individual anchor without influence of the edge distance | Concrete C20/25 to C50/60 s ≥ 3 hef c ≥ 1.5 hef) | Fadm [kN] 1) | 2,4 |
| 1) For statically indeterminate, redundant, non-load-bearing systems (anchors in a redundant non-structural system) in accordance with EN 1992-4. The partial safety factors of the resistances γM regulated in the approval/assessment and a partial safety factor of the actions of γF = 1.4 have been taken into account. For information on combining tensile and shear loads, on axial influence and the influence of the edge distance and on anchor groups, please refer to the appropriate guidelines, e.g. DIN EN 1992-4. The admissible loads per fixing point can be found in the corresponding national regulations of the EOTA member states. These may be lower than the admissible load of an individual anchor. | |||
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!